| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
IPv6 support for SocketCore class.
TODO: In SocketCore::establishConnection(), this is insufficient
to
determin the failure of connect() here because the socket is
non-blocking state. The next addresses should be tried after
select().
TODO: NameResolver still uses c-ares(<= 1.4)
ares_gethostbyname().
If c-ares 1.5 or newer is installed, ares_getaddrinfo() should
be used
instead which address family independent.
TODO: DHTRoutingTable{Deserializer,Serializer} currently saves
peer
information in a compact peer format which is for IPv4 only.
Some BitTorrent functions in PeerMessageUtil still depends on
IPv4 but
this is a spec of BitTorrent protocol.
* src/SocketCore.{h, cc}
* src/PeerMessageUtil.cc
* test/SocketCoreTest.cc
* test/PeerMessageUtilTest.cc
* test/DHTConnectionImplTest.cc
Handle IPv4-mapped addresses.
* src/DHTNode.cc: Now identity is determined by node id.
* src/DHTMessageTrackerEntry.cc
Because now PeerMessageUtil::unpackcompact() could fail, the
caller
should handle it.
* src/DHTRoutingTableDeserializer.cc
* src/DHTMessageFactoryImpl.cc
|
|
|
Added DHT functionality, compatible with mainline.
DHT is disabled by default. To enable it, give --enable-dht to
aria2c.
You may need to specify entry point to DHT network using
--dht-entry-point. DHT uses UDP port to listen incoming message.
Use --dht-listen-port to specify port number. Make sure that
your
firewall configuration can pass through UDP traffic to the port.
The routing table is saved in $HOME/.aria2/dht.dat.
* src/DHT*
* src/BNode.{h, cc}
* src/PeerInteractionCommand.cc: enable DHT functionality for a
particular torrent.
* src/Data.cc: Rewritten ctor.
* src/OptionHandlerFactory.cc: Added --enable-dht,
--dht-listen-port,
--dht-entry-point.
* src/DefaultBtInteractive.cc: Send port message if dht is
enabled.
* src/RequestGroup.cc: Initialize DHT functionality. When
download
ends, remove BtContext from DHTPeerAnnounceStorage.
* src/BtPortMessage.{h, cc}: Rewritten.
* src/message.h
* src/OptionHandlerImpl.cc
* src/option_processing.cc: Added --enable-dht,
--dht-listen-port,
--dht-entry-point.
* src/Dictionary.{h, cc} (remove): New function.
* src/prefs.h
* src/DefaultBtMessageFactory.h
* src/BtHandshakeMessage.cc
* src/ActivePeerConnectionCommand.cc
* src/SocketCore.{h, cc}: Added datagram socket support.
* src/DefaultBtMessageFactory.cc
* src/BtSetup.cc: Add BtContext to DHTPeerAnnounceStorage here.
Create DHT commands.
* src/BtMessageFactory.h
* src/PeerMessageUtil.{h, cc}
|
